AudiModel:: a4 tdi avant estate (b8) volcano red. Audi Year: 2011. Posted April 7, 2023. ive managed to source one from eBay 😁 from experience of doing the aux belt and pulleys i found it easier to take the See for the full procedure on how to diy tdi engine timin Timingbelt replacement on 2013 VW jetta tdi CJAA 2.0L TDIcouple tricks to save you some time and extra work.LinksTool kit8MILELAKE Compatible with Audi and Tosupplement the timing belt procedure I created a video showing the tensioner procedure I'll also clean up the torque chart at the end. Defer to the ones in the text. Last edited: Jan 26, 2012. 7. 740GLE 2009 Jetta TDI Candy White Manual, 2009 Jetta TDI Salsa Red DSG, 2006 Jetta TDI Candy White Manual Jan 28, 2012 Removethe 13mm nut on the tensioner pulley. Do not lose the washer. Slide the belt off of the water pump, then take the belt off of the rest of the components. Remove the tensioner. Remove the three 10mm bolts from the water pump. These bolts have a weird thread to them, so do not lose them. Remove the water pump. 15- Camshaft adjuster. 16 - 20 Nm plus an additional 45°. ¤. Replace. 17 - Intake camshaft. ¤. Check radial clearance using Plastigage (roller cam follower removed) wear limit: 0.1 mm. ¤. Installthe camshaft pulley. Loosen and tighten the adjusting nut to tighten the tensioner belt. Install the timing balancer belt pulley and lower cover. Then, tighten the bolts. Install the crank pulley and bolt. Rotate the crank pulley 5-6 revolutions counterclockwise, and ensure TDC marks are still in line. Re 1.6 Diesel torque specs. Right, don't hook up the injector lines before you rotate the pump a few times. Because you might be pulling it back off to adjust the belt. Putting just one of the rear bracket bolts in with the plan to pull the pump and finish the job is probably fastest. 9RP8g.